The motherboard is not the most exciting part of the system, but most importantly. In addition, the maximum capacity, which can be somewhat difficult to install, but with care is not difficult. There are ways to install the motherboard in a few simple steps, including mammoth eATX boards, either the more common ATX or the smaller mATX or ITX options.
If you are still struggling when buying a motherboard, there are great options for gamers.
Step 1: prepare the tool
It is important to get all the tools you need to properly protect yourself and your hardware before installing PC components. That is, you need to wear an antistatic bracelet and perform the installation on a nonconductive surface. Do not install on carpet floor.
For motherboard you will want a long Phillips head screwdriver. It is advisable to fix the screw with a small magnetic tip whenever possible. Needle nose pliers are also recommended to remove the screws inside the intestines of the PC case.
In addition, if you have any questions about the board, we recommend checking the work in progress, and recommending appropriate lighting for convenient use of the motherboard manual.
Step 2: Fix the standoffs
The motherboard is a sensitive electronic device, so we do not want it to touch the conductive chassis of the case. That is why it is necessary to install the standoffs before installing the main board itself. You can screw the motherboard directly with male thread with female thread. They are often brass, but sometimes painted black. You should have received several in a small bag with the motherboard or with the bag.
In most cases they are pre-mounted but do not fit the specific shape or size of the motherboard you are using.
To determine where and where to screw, refer to the motherboard and case manual or find the eATX, ATX, mATX, or ITX notes on the motherboard tray. When you find the right position, tighten it by hand. This can be a bit tricky, but you don't have to use it to use it. If you think it is necessary, it is usually because the standoff alignment is incorrect. Please readjust and try again.
Step 3: install the I / O shield
The final step on the motherboard itself is to install the I / O shield. It is a silver or black panel that protects the rear port of the motherboard and comes with the motherboard in a box.
Find it and press it to the rear gap of the case. It should be clear where to go, but you should check your direction again before you check your direction again.
Step 4: Install Motherboard
At this point, you may want to install the CPU first, but this is not required. For more information on this, how to install a CPU, whether AMD or Intel. To install the motherboard, carefully put it down in the case. Depending on the chassis, it can help if it is tilted obliquely toward the front of the case.
I am trying to align the screw holes on the board with the spacer I have mounted. It also fits well on the rear I / O shield and ensure that a piece of metal does not cover the port.
Use the screws included with the motherboard. You may need to gently fix the motherboard in place with the first screw inserted, but once you have the screws, you should have no difficulty in tightening the remaining screws. Unscrew and start again.
It is recommended to tighten the screws a little and tighten the screws little by little before placing them.
Step 5: power cable
To power the motherboard, you also need to connect the power cable. On most boards this means a 24 pin long connector and a smaller 4 or 8 pin connector. The former is usually on the right side of the motherboard after installation and the latter is usually near the top. Layout may vary, please refer to your motherboard manual.
Route the cable in the desired location, then carefully push it into each slot. If you're not sure, check that the power socket is rounded and squared so that you can't mistype the input.
When complete, it applies to other components in the build. For more information about PCs, see the guide on how to build a PC.
Editors' Picks